Categories
Contact Us

Add: 3/F, Yuehua Industrial Park, Songbai Road, Gongming Street, Guangming District, Shenzhen, China, 518106.
Tel: +86-755-23197735
Mob: +8618675646976
E-mail: admin@wowpopdisplay.com

Cases
Home > Cases > Content
The Opening Problem of The Gift Box Display Bonding
Mar 12, 2019

wow display

In the process of binding a packaging product such as a gift box display, the following problems are always prone to occur: the amount of the glue is too thick, causing the glue to overflow after the pressing, which affects the appearance of the product, and is also prone to occur between the gift boxes display. Stick to each other. If this happens, it should be left open for 2 to 5 minutes after brushing. After the adhesive is slightly dry, press it again. The glue is too thin and the drying time is too long, which leads to poor adhesion and sometimes no adhesion at all. When this happens, you should read the instructions to the manufacturer according to the instructions.


No pressing or too little pressure will cause the bonded product to automatically bounce off. This is mainly for products with a high stiffness, so it must be pressed for at least half an hour because there are many adhesives that are contact-type adhesive. Therefore, the two bonded surfaces must be effectively pressed. In the unit time, if the initial adhesive force is less than the product elasticity, the product will bounce off, so the general product requires a pressing time of 0, 5 hours.


In order to save raw material costs, some manufacturers use laminating glue and milky white glue to glue the box or use a larger amount of water to dilute the adhesive, resulting in insufficient bonding fastness and poor adhesion on the film. This situation is very dangerous, and it is also a violation of the bonding principle and process. It is hoped that the adhesive users will not cause greater damage to themselves due to the blind use of glue.


The gift box display will appear degummed during the winter season. This is mainly because some adhesives have poor low temperature resistance. Below 5 ° C, the surface of the adhesive will lose its activity, causing the adhesion to drop or disappear. In the hot summer, the sticky gift box will also appear in the warehouse or transport car, and the bungee will appear. This is mainly because the high temperature resistance of the adhesive is not good. At 50 ° C to 60 ° C, the adhesive layer becomes soft and the strength becomes small, which leads to degumming of the gift box display.


The bonding effect of the gift box in the early stage of sticking (usually half a month) is very good, and as time goes on, the debinding of the gift box displaywill occur. This is mainly because the bonding durability of the adhesive itself is poor, mostly because some plasticizer is added to the adhesive. As the time goes on, the plasticizer migrates to the paper base, causing the rubber layer to become hard and brittle. Degumming. On the other hand, because the adhesive contains a large amount of unsaturated bonds, the aging resistance of the product is not good. The storage period is prolonged and the film becomes brittle, and the product is degummed.


If the warehouse is very humid, it will be stored for a long time, not only the humidity of the product will exceed the standard, but also the product will degumming. This is mainly because the product absorbs moisture, and the water resistance of the adhesive itself is not good, resulting in softening of the rubber layer and delamination.


  • Newsletter
  • Categories
  • Contact Us

    Add: 3/F, Yuehua Industrial Park, Songbai Road, Gongming Street, Guangming District, Shenzhen, China, 518106.
    Tel: +86-755-23197735
    Mob: +8618675646976
    E-mail: admin@wowpopdisplay.com

  • QR Code
  • Copyright © Shenzhen WOW Display Industrial Limited All Rights Reserved.